- howdy folks I need some advice
-
Registered
howdy folks I need some advice
I have a maxNC and am replacing the blown PSU and controller with a gecko g540 controller. The wire setup is the basic red, green, blue, black AND there is a (to the motor) ground and the end wires for the coils are all connected to a white wire so I have 6 wires at the end of the cable. That means I have the 4 basic wires plus 2. Where do those two go on the 9 pin connector? And I have tried to post an image but I just get the box that wont close.
Similar Threads:
-
- howdy folks I need some advice
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules