- Africa Motion controllers
-
Registered
Motion controllers
Hi guys,
I am starting to look into dragging my old Mach 3 setup into the 21st century. Specifically I am worried about obsolete PC and parallel port constraint.
I know about PCI parallel port cards, that is also not completely foolproof. Finally I understand the quality of motion is just better with a motion controller.
So the question is:
Has anyone locally used a motion controller with Mach 3, if so which one and any experiences to share.
I am currently trying to make up my mind between Smoothstepper ( $159), UC300 ($115) and Dynomotion k-flop ($249), and leaning towards UC300 ($$for $ obvious$$ reasons$$$)
Similar Threads:
-
-
Member
Re: Motion controllers
Hey,
I have a Smootstepper and UC100 (smaller version of UC300) and both work great.
-
Member
I am also using the smooth stepper , works great !! Highly recommended
- Africa Motion controllers
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules