can a template get corpted ?

[Craigpat]

I think my template my have been corrupted.
I do an extrude / cut that intersected and i seem to have a inside lip left over or i guess in short it just didnt look right yet all the measurements were correct

-Any ideas or thoughts ?
-should just scrap that temp and make a new version

-If you look at the 2 tee shapes
-look at the inside contors where they intersect #2 looks like it isnt symetrical as #1 is

-Im i getting sloppy ?
-I am working in 64 ths should work in dec inch
- On # 2 it the lip did not show but seems to have cut a larger hole then defined

Also i have not done a fully definded scetch and have not had this issue before. When i measure my circles i use smart dimension aswell

-Any thoughts would be helpfull

Craig

[tobyaxis]

Any file created on a pc can get corrupted. DLL's can too. i have now specifics on how but they do.

Sorry I have no real help for you.

[Tomorrow_man]

Change your units from fractions to decimal and check the sizes of the 1/16 holes.



TM

[Craigpat]

I do think my template went south on me. I tried with the stock part template and my measurements via smart diamension and snaped seem to be correct . Thanks for your input

craig

[Tomorrow_man]

In the example file, the 1/16 holes were different.


TM