| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Solidworks Discuss Solidworks software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
03-02-2009, 08:05 AM
| ||||
| ||||
| I was quite happy to go to 09. I found 08 to have a massive amount of stupid bugs and it crashed constantly (not been this bad since the 03 version). Maybe your findings are different? Also - would it not take 3-4 years of maintenance savings to pay for a new release? (it does by my math)
__________________ www.integratedmechanical.ca  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2010 drives not running normally. | Splint | Servo Drives | 12 | 07-06-2008 09:56 PM |
| US Digital E2 encoder & Rutex 2010, somethings not right... | Splint | Servo Drives | 1 | 11-30-2007 07:20 PM |
| CAM Programming helps a new begynner with the Sherline Mill 2000 (2010) | AlfSkaar | General CAM Discussion | 8 | 09-03-2007 08:39 AM |
| 2010 Tool Not Available - Fanuc Om | PPM | Fanuc | 3 | 08-24-2005 03:22 PM |
| 2010 power requirements? | Splint | Servo Drives | 1 | 06-26-2005 08:21 AM |
| | |
Linear Mode
