default setup to english - CNCzone.com-The Largest Machinist Community on the net!

Craigpat · #1 02-24-2008, 02:41 PM

Does nayone know how to set sw 07 to english (dec or frationa inch) on start up . I have been setting it up by changing it every time i start a new part. And i am getting kind of tired/lazy of doing it everytime. i have looked for a setup to save but cant seem to find it

thanks in advance
craig

Craigpat · #2 02-24-2008, 03:29 PM

Never mind i figured it out WOO HOO im not an idiot just has to read some instructions. But where is the fun in that

Craig

tnik · #3 02-25-2008, 06:27 AM

yea, the SW tutorials are a big help when your starting out.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
default units	canadamaxxer	Solidworks	11	10-07-2010 01:05 PM
Default SL-20 parameters question?	PaintItBlue	G-Code Programing	0	11-01-2007 05:48 PM
Mastercam 9.1 default settings	Fatty	Mastercam	2	06-28-2006 11:04 PM
Default layer oncncXP	Ken_Shea	OneCNC	7	05-08-2003 03:48 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)