A question on assemblies

[Craigpat]

Gents,

I drew and posted the table base the post is called (look what i drew) Now that was done as a single part. So go figure i cant make a parts list or exploded view ( ha ha new guy mistake). Will i need to make a new part for every piece . ie a leg is made of 6 pieces 4 leg sides and 2 leg filler pieces. If i understand right i have to draw individual part for each ?.

Thanks for the in put
Craig

[tnik]

you could use the weldment feature, make a profile for each peice, then create the weldment.. each peice would be in your 'cut list'..

[tnik]

or you could use the 'split' feature..