External thread

[Kai_DK]

Why is it so hard to define an external thread?
Are there a function which I haven't found?
Hole feature -> M6 , job done.
Bar feature -> M6 ???????

[age_cph]

Hej igen Kai,

Med mindre de har tilføjet det i 2011, findes den funktion (ganske uforståeligt) ikke til udvendigt gevind.
Du bliver nødt til at tegne gevindprofilen og så lave swept cut på en helix.
Se filen!

Allan

[Kai_DK]

Tak for det / Thanks.
I was hoping for another answer :-)

[tnik]

Kai DK,

Create your shaft, goto insert > annotations > cosmetic thread

There you can set your M6 thread, or any other thread you want..

[Kai_DK]

Yihaaaa!
Thank you very much.