SW 2009 Question

[ou812]

Hi, I recently switched from UG NX4 to SolidWorks 2009. I some how dragged the main toolbar from the top and can't get it to snap back. They only place I can get it to locate is the right side.

Does anyone have a suggestion on getting the main toolbar (Features, Sketch,Evaluate....) back to original home?

[Mike 1948]

Hi, I recently switched from UG NX4 to SolidWorks 2009. I some how dragged the main toolbar from the top and can't get it to snap back. They only place I can get it to locate is the right side.

Does anyone have a suggestion on getting the main toolbar (Features, Sketch,Evaluate....) back to original home?

You should be able to drag it out into the working area, drop, then drag the bar and place the cursor over the small icon that pops up in the middle top of working area. this is in 2010 but I think 2009 is the same

Mike

[giz]

You should be able to drag it out into the working area, drop, then drag the bar and place the cursor over the small icon that pops up in the middle top of working area. this is in 2010 but I think 2009 is the same

Mike

It is the same.

And in case it every happens again, if you simply double click the top where it says 'Command Manager' and it will snap back to where it last was.

[CNC Lurker]

Drag it to the arrow highlighted in the screenshot.