Need Help!- About Controller of SolidCam 5 asix type Head_head CNC

[atutu]

I am very interesting in software SolidCam about programming 5 axis of SolidCam (At the momnet I'm using version SolidCam 2009), but when I setup it then software don't show full support in part 5 axis in SolidCam, haven't support file *.mac and *.gpp of mechine CNC type Head_head (same Image). can you hepl me, please.
Thanks you very much and soon receive your feedback

[turcomemo]

i am interesting to but still cant adjust it

[veteq]

Hee Guys ,

Your dealer where you bought it cann help you out.

They will give it to you for free, just ask them...

Kind regards,

Roy B.

[turcomemo]

Originally Posted by veteq Hee Guys , Your dealer where you bought it cann help you out. They will give it to you for free, just ask them... Kind regards, Roy B.

you are so sweet veteq. how i cant remember it.... let me call them but but i dont have solidcam license cus i a student and dont have any money for this

[Brakeman Bob]

So how have you got SolidCAM to work without a license? Do tell.

[veteq]

think he downloaded and installed a program called Vuze and searched on the piratebay website for SC. and opened it, then waited till the program was in his documents and readed the read me file in it...

Nobody cann or will help you here for 5 axis...

[pinguS]

I didn't even know they did a student version, otherwise I would have learnt it when I were younger!!

[yasemintalay]

Originally Posted by turcomemo you are so sweet veteq. how i cant remember it.... let me call them but but i dont have solidcam license cus i a student and dont have any money for this

I think that he runs SolidCAM Demo version.