MAHO 432 Post Processor

[micktat]

Hi, I'm using SolidCam to create the Gcode for my machine.... with a MAHO 432 controller.

There is only the mac file in the installation folder but when I try to use SolidCam the drilling cicle write some error....

But there isn't the GPP file for the machine parameter....

There is a solution for my PROBLEM???

Thanks

[desmo special]

Hello Micktat,

I'm looking for a Solid cam postprocessor for the Philips 432 controller.
Is it possible tat you send is by e-mail to me?
Did you fin a solution for the drilling cycle
Maybe I can look how to solve the drilling cycle problem.

Kind regards, Desmo special

[micktat]

Hi, I'm using SOLIDCAM 2007, It has a "non-perfect" post for MAHO 432 but I can work with it...

For the drilling cicle I rewrite in the right mode the GCODE....

I can send to you the MAC file that the SC2007 use for GCODE, but for the newest it don't work... is it necessary the GPP and I haven't it...

Thanks

[Sven H.]

Hello,

I seek a SolidCAM post-processor for a Deckel Maho DMU 60E with Heidenhain control MillPlus V321.
I would be grateful if someone could e-mailed to:
svenherweg@gmx.eu

Greetings from Germany

sven