Need Help! Help,I need a solidcam 2008 post for Maho - CNCzone.com-The Largest Machinist Community on the net!

southpool · #1 10-28-2008, 03:10 AM

Help,I need a solidcam 2008 post for Maho and Mahomat.
My English is low.
I need the post
The mashines are old and i need the post other i im fired.

desmo special · #2 12-31-2011, 05:23 PM

Hello southpool,

Did you find the SolidCam postprocessor for the 432 controller?
Can you send it to me by e -mail?

Thanks in advance,
Kind regards,
Desmo special.

ivo0230 · #3 01-03-2012, 09:19 AM

Hello, I need help with same postprocessor 432 for MAHO .
I try to modified other pp but without success.
If anybody have that pp, please contact me.
I have problems with pp for HURCO 4axis.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- SolidCam 2007 with Solidworks 2008	semo	SolidCam	8	11-13-2010 02:51 AM
ı need a post processor powermill for maho 800 E .	onomatope_	Post Processor Files	0	09-22-2007 09:01 AM
SolidCAM post processor	psyko2099	Post Processor Files	0	09-06-2007 02:03 AM
Deckel Maho 63V Post	louorfran	Surfcam	1	06-12-2007 12:14 PM
Deckel Maho 63V Post	louorfran	Deckel, Maho, Aciera, Abene Mills	0	06-09-2007 06:55 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)