Newbie- Haas TM-1 Post processor needed

[keithki]

Does anybody have a good Haas post processor that they can send me? I have a TM-1 and am just getting started. Thanks.

[simonlawrence]

hi , i just bought a new tm1 mill from haas. the belt that drives the spindle rides up and down the 2 cogs in clockwise - counterclockwise . it then rubs . haas are to put 2 belts on to cure it . the engineer tried to set the motor screws front and back and this helped but it still moves ad rubs . has anybody seen this before, does anyone know if their mills belt runs in the middle or does it ride up and down the spindle cog , thanks






I SPOKE TO HAAS 2 DAYS AGO , STILL WAITING FOR A FORMAL SOLUTION AND RETURN OF 2 EMAILS

[SORCHEROR]

yes,i have the same problem for 4 years,makes alot of noise too,its an alignment issue
i never did try to fix it,soon i have to replace the belt and will try to align it better than

[SORCHEROR]

as far as a post processor.for what software?i have one for master cam

[simonlawrence]

has anyone got any pics or lins to pics of a haas tl1 or tl2 steady rest , thanks

[Baldoom]

Well, I need a post for the TM-1P for Featurecam. If anyone has one that would be awesome. The post for the vf is not at all the same I hate having to adjust my speeds, feeds and depth of cuts all the time. Lack of power on this lil guy. Thanks again.

[foxsquirrel]

Just call your rep and they will email it to you. Their stock Haas mill post will work fine. They did create a custom post for my machine because we use 20 fixture offsets and it was based on the their stock haas post. Its been flawless.