Using work on selected faces problem - CNCzone.com-The Largest Machinist Community on the net!

06-10-2008, 11:05 AM

BJ-DEKA

Join Date: Oct 2007

Location: USA

Posts: 13

Using work on selected faces problem

Hi all,

I have recently been having some trouble with Solidcam calculating tool paths and was wondering if anyone else has experienced this or had any tips or tricks.

When I try to calculate a tool path using work on selected faces sometimes it will calculate down to 0 then hang up. When it hangs up I can not cancel out of the calculation either. In the task manager it says the program is still running but I have tried letting it sit over night and its still hung up and the only way out is to end program in the task manager.

Anyone had anything like this?

Thank you,
BJ

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Selected Axis, Step Size LED indicators	mikkojay	Mach Mill	2	01-11-2008 02:10 PM
Sphere size defined by three faces	Daox	Solidworks	16	09-24-2007 08:37 PM
Selected Block Not Addressed	Hotrodder2u	Bridgeport and Hardinge Mills	2	08-02-2007 10:14 AM
Rock and Stone faces	SamLS	General CAM Discussion	4	10-27-2005 10:22 PM
No drive surfaces selected	justCNCit	Mastercam	21	08-18-2005 11:55 PM

All times are GMT -5. The time now is 12:20 PM.