post pro for num

[marktill]

can any one help i have a 4 axis num and need a PP

regards mark

[Adam Hubert]

Mark,

You might accomplish it with some of the other CAM programs but I don't think a short statement on this forum that says "give me a post" will get much response. For one there are not that many seats of SolidCAM in the world and for another only a tiny fraction of all the users of SolidCAM use this forum.

You can try using one of the default posts that comes with the install. Chances are slim that one is all that close to what you need. Especially when you factor in the 4th axis.

or

Take the closest default post and modify it to suit your needs. It sometimes is not easy but sample files and instructions are there.

or

Either get or purchase one from a reseller. I've heard that there are some very knowledgeable SolidCAM resellers in the UK.

Good Luck

can any one help i have a 4 axis num and need a PP

regards mark