| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SolidCam Discuss SolidCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-30-2012, 07:38 PM
| ||||
| ||||
Hello Just wondering if anyone else is having problems using there 2011 tool tables in 2012. My tap feedrates are incorrect if I import a tap from a 2011 table but are ok when importing from a 2012 table. Drill depths are also incorrect. After a few broken taps and drills not going all the way through the part, I'm getting a little OP.  |
|
#2
02-01-2012, 01:56 AM
| |||
| |||
| I haven't come across that yet but I have found that in Turning tool libraries drills that were mm are now in inches. Also, while I am on it, how do you define a stationary drill in SC2011 Turning? |
|
#3
02-01-2012, 07:08 PM
| ||||
| ||||
 I also notice some of my speed/feed got swicth from Inch to metric as well. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Saving Tool Tables | Smitty911 | Dolphin CADCAM | 13 | 03-15-2008 02:34 PM |
| tool tables | synv | SolidCam | 1 | 01-13-2008 11:56 AM |
| Tool Tables | mmorton9 | Mach Mill | 2 | 01-17-2006 04:01 AM |
| Tool Tables | mmorton9 | Mach Software (ArtSoft software) | 0 | 01-09-2006 05:01 PM |
| Tool tables | Nimrod | Mastercam | 4 | 11-24-2003 02:31 PM |
| | |
Linear Mode
