NEED HELP WITH A .GPP FILE

[IlFincoITA]

Hi! I'm trying to edit an old .GPP file for a deckel Fp4MA. Everithing is working just fime but since this machine need that z compensation must be wrote after any z changes i've discovered a mistake. It puts the D+ code after Z changes but it does this change aven after a x or y change and i can't discover where is the problem into the .GPP file. Could someone check this .GPP file? Thanks a lot...

[foxsquirrel]

Please post .gpp uncompressed because I cannot unzip anything. It might be easier to search the .gpp for "D" and see what is going on. Have you performed a dry run without a tool? the "D" might be moot.

[IlFincoITA]

OK here's the file... on this machine I have done only small and simple program. I found the error that was in line 488 where I put ",' D+'tool_number" after "' z'zpos" but now the only d+ i get is after tool change... or to be more precisely after the first rapid movement. For the other z movements the d+ is no longer reported. I'm not capable to do this...

[Adam Lilja]

Turn your trace on in your .gpp before you post your code by taking out the ; in this line

; trace "all":5

you can trace it from a value of 0-5 to get simple to more complex breakdowns of what is going on.

Go from there and see what it gives you.