Tool starts and cuts deeper than geometry ?? - CNCzone.com-The Largest Machinist Community on the net!

Spencer myers · #1 01-13-2012, 07:09 PM

Does any one know why when the starts it cuts deeper than the geomtry only in the very first starting point. It doesn't do it on spiral path. All other paths it does. Is this a cord system thing, a tool thing, don't know.

dengo · #2 01-19-2012, 02:35 PM

I used to have these sorts of issues a long time ago when using 3D milling. Switched to HSM and things improved no end. Also make sure that your Lower Level isn't set up too low.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Same tool - different cuts ?	hmc710	Colchester Tornado lathes	0	07-25-2010 02:10 PM
Problem- Tool Geometry / Offset	WaterjetWillie	Daewoo/Doosan	2	06-12-2010 11:10 AM
Looking for geometry on a dimond cutting tool for surface cuts	Craigpat	Solidworks	0	02-10-2009 08:53 PM
Loading tool geometry with G10 ???	theemudracer	Fanuc	10	12-10-2007 07:06 PM
M00 within cuts with same tool	shawncnelson	Mastercam	3	05-05-2006 06:38 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)