I started solidcam last year, since then SP2 and SP3 came out because of the bugs I found.
I love solidcam because I am a X mastercam user but I think they need to get there heads out of there ass and get all the bugs out of there softwere.
Finaly I am happy with 2010 SP3 but afraid to start 2011.
What do you guys think.
I have only found a few little problems with 2011 SP0, havent found any in sp1 but have only been using it for a week or so. and the bugs I saw before arent there anymore. Only 2 problems I noted. They need feedback to fix bugs as you never catch all of them. I noticed 2 one was a graphic selection issue with drill point where it would show up in the list but would not highlight all the time on the screen, but was selected, the other was in the 3-d tool paths. When you would try to change a constant z from a top down to a bottom up it would not change but if you selected the bottom up when you first did it, it was no problem, you could switch between the others no problem. I havent noticed them in SP1.