Removing fixture

[pinguS]

Hi All

Just wondering how you remove a fixture from the setup when I move over to using another Mac position.

I have basically done alot of milling using Mac 1 Pos 1, now a few ops remain on the same machine, solidcam file etc. But on the opposite side, all I want to do is remove the fixture, so that when I solid verify, its not there. The only option I can see is to define another fixture, but I don't want to, just not have anything there, is this possible?

pinguS

[Brakeman Bob]

Yes, you can just turn it off in SolidVerify using the "Display Fixture" icon. It is the second from the end on the right hand side of the bottom row of SV icons. It looks like a square block being held in a vice.