I Machining video Posted

[MKproto]

Well
Here it is guys this is the video I was telling you about.

[nomedia="http://www.youtube.com/watch?v=r3bmC8McXc4"]YouTube - Test cutting[/nomedia]

3/8"-5 FLute accupro Endmill
Iscar ER-32 Collet chuck and Collet
6061t-651 Aluminum

Machined on a 2004 Haas SUperminimill with the 15k RPM spindle and HSM.

Programming took about 5mins.

(added below)
Feed rate was set to a max off 634 IPM, tool never comes out of part. Corner rounding on the machine is set to .0002" G187 is set to finishing.
Spindle speed 14,900 RPM
DOC .700"
Chip load was set to .0035"


Enjoy.