I have an Ethernet Smooth stepper with a C32S - DUAL PORT MULTIFUNCTION BOARD and a Clearpath servo motor CPM-SDSK-3432S-RLN. Need help can not figure out how to connect the 8 wires to the C32S board. Note the C32S board has RJ45 jacks (RJ45 has also 8 wires) and the Servo wire are plain wires. That's the problem I’m having I'm going to have to splice the wires together, but don’t know which wire goes with which wire. Thanks in advance.
Similar Threads:
Did you configure the inputs on the motor with the Teknic software, and do the motors work using the Teknic software?
09milam,
See attached pdf for wiring.
Jeff...
Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.
Jim is right, you have to configure the motor using Teknic's MSP software. You can download the software here: https://www.teknic.com/downloads/
Then just connect the USB on the back of your motor when the motor is powered. Once you're connected you can autotune, and select your step and direction mode.
Thanks guys, everything is up and running the motor is finally enabled and mach is configured. What the problem was my wiring isn't worth nothing but still learning. But having one problem with this [Move off limit switches before executing MDI Mach4] how do you fix this I have no physical switches? I'm assuming once this is solved the motors will move.