nice!
nice!
Tim
Tormach 1100-3 mill, Grizzly G0709 lathe, PM935 mill, SolidWorks, HSMWorks.
Wow. Dan do you mind sharing your tool/insert choices if u know them.
Thanks Tmarks!
Sure Brian...
This one came from Shars...
The holder is a # 404-1837
The insert is a # VBMT 331 EM YBG205 SKU # 424-1874 Ansi VBMT 331
This one is a left hand holder. The insert is actually for stainless but I find a lot of inserts for stainless can give super nice finishes in aluminum, brass & copper. Even on T5. Hope this can help. Dan.
Wow - so you did the whole part except the threads and parting with that one tool?
I use an MVJNR (which I just looked is a Neg Rake) - not too sure when to use neg vs pos rake.
I did the entire center section, angles & etc with that tool as well as the OD on the ends, then a grooving tool... then threading tool. I didn't know if I would like that tool or not when I purchased it...thats why I bought a cheapie. It has about become the favoite tool in the turret. It is a cheap tool BUT... I have $300 Sanvick tools that don't any better finish at all.