Hi all,
Just in the process of setting it up and already a problem. I may have inadvertently jammed the table feed process as it would only make 1/2 a
turn of the feed crank(x axis) and then stall in rapid feed. Work feed (normal speed) is no problem. Then the 20 amp slow blow fuses let go. Changed them,
checked that all controls were in nuetral,turned the power on and had a green light. pushed the start button and blew two more fuses. Could the feed motor be shorting out. There was no indication of a HOT electrical problem until the fuses blew. Any help with the above problem wil be welcome.
Also any suggestions on leveling the table would be welcome.