| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SmartCAM Discuss SmartCAM here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
02-07-2008, 10:15 AM
| ||||
| ||||
| A few of the classes I took used SmartCAM and I would have to say while its not terrible it left a lot to be desired. Maybe they have made improvements to it but from what I experienced it was not to user friendly and could be hard to manipulate compared to other software. Good luck finding tuts I bet Smartcam has some to sell you. Bo    |
|
#3
05-26-2008, 06:18 PM
| |||
| |||
| I have been using SmartCam production milling for about 4 years. Is there anything I can help you with? I'm sure the version I'm using is an older version, but it should all be rel. if I can get all my DAEWOO cnc work done. Let me know, Russ 724-238-7058 |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone still using SmartCAM | ltmquik | SmartCAM | 23 | 02-07-2012 11:34 PM |
| mastercam video lessons wanted | Jedi | Mastercam | 38 | 05-08-2010 08:35 PM |
| Free MC lessons for beginners | jorgehrr | Mastercam | 9 | 05-07-2007 01:09 AM |
| Lessons In Electronic Circuits | epineh | General Electronics Discussion | 2 | 10-12-2006 06:05 PM |
| What were your lessons learned? | WoodSnarfer | DIY-CNC Router Table Machines | 18 | 12-11-2004 09:48 PM |
| | |
Linear Mode
