Hello, i have a dilemma. I have a special profile thread, and im wondering if theres any way i can synchronize turning cycle to start from same point as milling. Control im using is 840d siemens.

Lead is around 20mm, and i'd like to mill most of it off, and finish it with multiple basic G33 cycles, i have the points for finishing and can program the milling part also, only problem lies with the synchronizing.

I dont have much experience with basic thread cycles, and im wondering how the control/machine calculates the start point etc, basic stuff.

Just wondering if this can be solved with "some" calculating, and couldnt find proper forums for this question so can poke me to right direction also.