Hi all,

I was just wondering if the siemens controller (840D) has the option for a delta radius correction in the G-code, just like the Heidenhain does: DR+0.1.

I'm just aware of the toolsetup table in Siemens and Fanuc controllers, there is an option for additional tool wear (Sounds to me like it is a delta correction?).

But I would like to call for a delta correction inside the g-code, like: M6 T1 R1 R+0.1

Or am I just spoiled with me heidenhain controller.....!

thanx,
LVX