Robotool CVM-1 knee mill(post 2) - CNCzone.com-The Largest Machinist Community on the net!

Paul in OK · #1 11-06-2009, 11:15 AM

Any one have one of these? May aquire one and would like to know if they can be set up to run off a pc rather than thru the original control box.
Any info on the machine appreciated.

skullworks · #2 11-07-2009, 03:40 AM

You would likely have to update the encoders - The Robotool CVM1 used fairly low resolution cause the Z80a control ran so slow.

Can't remember what type of amps it used but they are DC brush motors.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Robotool CVM-1 knee mill	Paul in OK	General Metal Working Machines	0	11-05-2009 04:14 PM
feedback on a Z axis kit for a knee mill and mill drill	extsuba	Vertical Mill, Lathe Project Log	1	03-31-2009 07:06 PM
Robotool cvm1 knee mill	WARREN PATTERN	Machine Problems, Solutions , Wireless DNC, serial port	6	10-02-2008 01:52 PM
Robotool Post?	dsr3	Post Processors for MC	11	10-09-2007 08:22 PM
Robotool Knee Mill	1FAST432	Knee Vertical Mills	0	06-25-2007 10:59 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)