Mitsubishi Control help - CNCzone.com-The Largest Machinist Community on the net!

justin · #1 03-09-2005, 06:08 PM

Looking for anyone who has experience with the Medelas Mo controls. I would like to input files that I create in bobcad through the RS-232 port?? The manual doesn't give much help???

2_jammer · #2 03-14-2005, 02:57 PM

Hi Justin,
I run a Viper VMC with a Mitsubishi Meldas 520 controller on it. If you give Mitsubishi a phone call at (714) 220-4796, they'll be able to walk you through any questions or problems that you are having. Unfortunately, the machine I have seems to be having problems in the networking area, so I'm afraid I can't be much more help. Hope this helps. Shane.

justin · #3 03-14-2005, 07:06 PM

thanks for the help with the phone number. I am geting ready to try the cadem that Al pointed out. It looks like a nice product? I will have more to tell later this week.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
G-Code to DXF	WayneHill	OpenSource Software	81	08-19-2009 10:54 AM
Visual Basic Controller Project	dwwright	Visual Basic	25	04-25-2009 12:53 PM
CNC Glossary	CNCadmin	CNCzone Club House	17	03-09-2008 04:08 PM
Fadals new Augusta control or 104d	Scott_bob	Fadal	67	09-29-2007 05:36 PM
HAAS Indexer Prodramming / Control	CAMmando	Haas Mills	8	06-10-2003 11:22 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)