|
|
|
Welcome to the CNCzone.com-The Largest Machinist Community on the net! forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
| Home Page | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Mark Forums Read | Advertise With Us | Ad List |
|
|||||||
| CNC Wood Router Project Log Post your CNC machine building log here only. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
09-28-2008, 02:41 PM
|
||||
|
||||
CHEAP DIY 4th AXIS SETUP (MDF BASED) - MUST SEE
Any body who want to install cheap MDF based 4th axis on machine, must see the following thread
 http://www.cnczone.com/forums/showth...=39588&page=27 Regards Khalid Last edited by Khalid; 09-29-2008 at 09:13 AM. 
|
|
#2
09-28-2008, 05:42 PM
|
|||
|
|||
|
That's really a nice addition to your machine Khalid! It couldn't be much simpler than that. Good job.
I have to say it though, somebody I know personally would have to make one from red oak and purple heart to make it look right on his own machine.  So now I suppose you are going to design a simple means to rotate the router front to back and side to side. (axes B and C?) CarveOne
__________________
"A $1,000 electronic device will almost always protect a ten cent fuse."
|
|
#3
09-29-2008, 09:10 AM
|
||||
|
||||
|
CarveOne, May be I will make a jig to hold the router 90 degree, but currently I am not planning to motorized myB-axis
5-Axis CNC is on my drawing board, Hope I will finish it within two weeks, and building will offcourse take a couple of months
|
|
#6
12-22-2008, 06:22 PM
|
|||
|
|||
|
Hi Khalid,
It seems that you have other projects and interests as well as this one, so if this project takes a while I'll still be checking for any updates you post. CarveOne
__________________
"A $1,000 electronic device will almost always protect a ten cent fuse."
|
|
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| REALLY cheap CNC! | blades | Benchtop Machines | 4 | 04-11-2008 08:32 PM |
| 2-axis ghetto cheap | blades | Benchtop Machines | 19 | 01-16-2008 04:29 AM |
| 5th Axis on the Cheap? | M30 | Haas Mills | 15 | 07-24-2007 09:45 AM |
| Dirt cheap Polyester PETP rods for Z axis??? | andy_ck87028 | Linear and Rotary Motion | 6 | 06-20-2006 04:45 AM |
|
|
|
Linear Mode
