Pre-Setter "Tool Eye" calibration? - CNCzone.com-The Largest Machinist Community on the net!

SmokinErb · #1 03-06-2008, 08:47 PM

Hey all I run a Mori ZL-200 and SL-154 with Y capability. Now i was wondering if anyone knows how to calibrate the tool eye so when a tool is touched of Then the Offset reads 0.0000 and you don't have to adjust the wear offset. I know when i touch off my tools to take them +.006 and they will cut at nominal. Any help would be great.

NL2000 · #2 03-12-2008, 03:23 PM

You simply have to adjust the parameters for the presetter.

Fanuc controls should be parameter 5015 for ID tools and 5016 for OD tools.

Mitsubishi controls should use parameters 2015 and 2016.

Before changing any parameters write down the current value.

If you are not experienced changing parameters, contact your local Mori dealer for assistance. Things can go wrong in a hurry if the wrong parameter gets changed.

SmokinErb · #3 03-15-2008, 09:00 AM

i figured it was a paramater thank you so much when i go into work on monday im going to have to check it out
thanks again cnc zone is awesome

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"low end" HF Spindle or "high end" router for about $1000?	biomed_eng	DIY-CNC Router Table Machines	12	08-20-2008 08:49 PM
BattleAxe "aka" Ball and Chain "aka" the wife.	ZipSnipe	CNCzone Club House	48	05-18-2008 10:53 AM
Has anyone looked at the "JET" or "Shop Fox" manual machines?	boosted	General Metal Working Machines	12	03-04-2007 10:33 PM
"tool slot number too large" code	dave6	Mach Mill	1	10-10-2006 06:57 PM
Tool height "touch off" tool unusable	DHK	DeskCNC Controller Board	6	05-06-2006 01:54 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)