3-Axis Bi-Polar Driver Board

[anoah]

Hi guys,

I'm not sure if this is the correct place to post this message. If no, could a mod please move it to the correct forum?

I have been looking VERY hard for a schematic or pcb layout for a 3-Axis Bi-Polar controller that will work with TurboCNC.

Does anyone happen to have or know where I can find one? Any format such as Eagle, jpg, pdf, gcode, dxf, etc would be greatly apprecited.

Thanks,

Albert

Similar Threads:

• Bi-polar driver, help please
• 3 axis driver board
• single axis driver and a b.o.b.,or multi-axis driver board
• Electronic Utopia Bi-Polar Board (or other Bi-Polar boards)
• 3/4 Phase Uni-polar Driver Board

[balsaman]

How about this one:

http://hans-w.com/modular.htm

Eric