I have just installed emc on a computer with the live cd .Which version I don't
know ,copied a stepper config into my file folder of emc.
When I run emc the file is in the tree of the folder , but I get an error message
tree file error.
your question is a bit vague.. One of the emc developers asked if maybe you have a space in the directory name? Can you be more specific about the error - maybe a screen shot?
Hello again Here is the message I get when I try to open up my mill.
Error main.f1.f2.f3 tree selection set:cannot select unknown node
"/home/rick/emc2/configs/ricksmill/ricksmill.ini
This is all new to me ,I have used mach3 in the past and I have just
found this coputer and did the live cd install. The step configure went
quite well, I just can't open it in order to run it.