- Laser Center Finder options for ShopSabre
-
Member
Laser Center Finder options for ShopSabre
I am looking at adding a Laser Center Finder to my ShopSabre ATC. I only know of two options vs going full DIY with parts found off of eBay.
One is through ShopSabre for a Laser Center Finder that can be hard-wired and controlled by WinCNC. Cost is $$$ including support and a macro that will adjust the spindle position to compensate for the laser offset. Never need to replace batteries on this one plus it comes with a custom mounting bracket.
The other is a Laser Center Finder that will mount directly into a collet, just like a router bit in one of the available tool holder spots. It is about 1/4 the cost of the ShopSabre add-on option. Welcome to Laser Center/Edge Finder I will lose one tool holder spot and need to manually turn it on and off.
Does anyone have experience with either one of these setups or an alternate option?
Similar Threads:
-
-
Registered
Re: Laser Center Finder options for ShopSabre
Come join this ShopSabre / WinCNC Users Group on Facebook https://www.facebook.com/groups/1141969885814946/
- Laser Center Finder options for ShopSabre
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules