I have a Shopmaster model 2000 with control box from The Control Group model 2.0 x 4 (I believe this was the standard box from Shopmaster). I am trying to get the machine to run under Mach3 but I have found that I need to configure the software for this particular machine and I'm having trouble. Has anyone else done this before? Does someone have a configuration file they wouldn't mind sharing?
Primarily what I need are the values I'm supposed to enter on the motor configuration fields (on each axis) for step pin #, dir pin #, step port, and dir port.
Any help is greatly appreciated. Thank you,
Last edited by eirigoyen; 04-09-2010 at 02:21 PM. Reason: needs a smilie face