Mach3 Configuration Shopmaster 2000

[eirigoyen]

Hello,

I have a Shopmaster model 2000 with control box from The Control Group model 2.0 x 4 (I believe this was the standard box from Shopmaster). I am trying to get the machine to run under Mach3 but I have found that I need to configure the software for this particular machine and I'm having trouble. Has anyone else done this before? Does someone have a configuration file they wouldn't mind sharing?

Primarily what I need are the values I'm supposed to enter on the motor configuration fields (on each axis) for step pin #, dir pin #, step port, and dir port.

Any help is greatly appreciated. Thank you,


Enrique

[dmauch]

I think you meant the software from the Motion Group.
Dan Mauch
www.camtronics-cnc.com
low cost cases and Geck drives

Originally Posted by eirigoyen Hello, I have a Shopmaster model 2000 with control box from The Control Group model 2.0 x 4 (I believe this was the standard box from Shopmaster). I am trying to get the machine to run under Mach3 but I have found that I need to configure the software for this particular machine and I'm having trouble. Has anyone else done this before? Does someone have a configuration file they wouldn't mind sharing? Primarily what I need are the values I'm supposed to enter on the motor configuration fields (on each axis) for step pin #, dir pin #, step port, and dir port. Any help is greatly appreciated. Thank you, Enrique