| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SheetCam Discuss SheetCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-13-2009, 08:21 AM
| |||
| |||
how do you control the direction of a cut or cut segment in SheetCAM? I use SheetCAM TNG, if that makes a difference I know I can choose a direction in BobCAD, but SheetCAM seems to ignore it also, I think I had a part once where it skipped around and cut various segments of the same cut in different directions...I went back and looked at it in BobCAD, and it had arrows pointing accordingly, so I figured that's why SheetCAM didn't cut it all in one go...but now, it wont do that again  |
|
#2
10-13-2009, 08:37 AM
| ||||
| ||||
| While I do have TNG, I am still using the older version right now. Just haven't made the full jump yet. Changing direction on a profile is done by switching climb cut on or off. Single lines are done by moving the start points.
__________________ Lee |
|
| Tags |
| cut direction, sheetcam |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which direction to cut? | tenaja | General Metalwork Discussion | 5 | 06-15-2009 09:06 AM |
| In Need of Direction | FrontlineArms | CNCzone Club House | 1 | 03-16-2009 05:29 AM |
| G320/G340 'Required Direction Setup' and 'Required Direction Hold' times? | margni74 | Gecko Drives | 2 | 12-05-2008 08:10 PM |
| Need some direction... | mredican | CNC Tooling | 3 | 03-09-2008 08:39 PM |
| Looking for some direction | Tristanc1 | General Metalwork Discussion | 5 | 05-27-2007 01:00 AM |
| | |
Linear Mode
