| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SheetCam Discuss SheetCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-10-2007, 12:36 PM
| ||||
| ||||
Not a great picture here, but basically I want to run a cutter around the whole of the perimeter of this part, but for some reason it stops and starts, leaving some parts of the profile out completely. No idea why this is.     |
|
#2
07-11-2007, 03:51 AM
| |||
| |||
| The most common reason for this happening is if the contour crosses over itself. Think of a figure 8 and the way it crosses over itself. Intersections like this really confuse SheetCam. If you send me a copy of the job file, I'll take a look at it and see if I can find out what is wrong. Send it to les {at} sheetcam.com (replace {at) with @) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surface contour toolpath (odd) | jnc | Mastercam | 1 | 04-22-2007 08:16 PM |
| Contour probe digitizing | Sanghera | Digitizing and Laser Digitizing | 1 | 02-04-2007 10:24 AM |
| Bad Contour Error while Pocketing | sundara | BobCad-Cam | 2 | 05-29-2005 07:10 AM |
| Closed Loop Driver vs. Closed Loop Computer | ojibberish | Gecko Drives | 3 | 06-08-2004 12:30 PM |
| contour profile | stevieboy | Mastercam | 8 | 10-15-2003 02:40 PM |
| | |
Linear Mode
