New to this and trying some test cuts but was wondering if anyone would share settings for the following:

Kerf Width:
Feed Rate:
Pierce Delay:
Pierce Height:
Plunge Rate:
Cut Height:
Pause at end of cut:
Lead in:
Lead out:
I'm trying to make a chart for the following metals:
1/16 mild steel
1/8 mild steel
3/16 mild steel
1/4 mild steel
3/8 mild steel
1/2 mild steel
1/16 stainless steel

I'm using Hypertherm Powermax 65. I would also like to know which consumables are recommended for each of the metals.
Any info on these would be greatly appreciated. Thanks, Rob

Similar Threads: