| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SheetCam Discuss SheetCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-27-2006, 02:24 PM
| |||
| |||
Hello, I have this piece with 2 layers inside and outside. After if finishes cutting the inside layer it's not generating the M05 code to stop the plasma cutter. Any ideeas what have i done wrong ? Cosmy    |
|
#2
05-28-2006, 03:26 AM
| |||
| |||
| Are you using a plasma post processor? You will get this problem if you use a milling/routing post. Go to Options->Select post processor and try plasma1 or mach2 plasma. Les |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
