| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| SheetCam Discuss SheetCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-25-2006, 01:28 PM
| |||
| |||
| PRoblem seeing dxf lines I'm using the latest Sheetcam, and Autocad 200i, I've got two DXF files ( version 12 ) that are nearly identical in content and as far as I can see , ARE identical in setup and settings. I can load the one up into Sheetcam no problem, create my cut paths, create G-code, no problems! But the othe rone, it shows as nop drawing lines - it's blank. Anyone got any suggestions? The file loads in Autocad just fine. I'm so frustrated at all this crap - scales wrong, no one reads a pdf, can't use this, can't do that, I've gotten ONE dxf file to cut in 6 weeks. I'm REALLY frustrated.    |
|
#2
03-25-2006, 01:48 PM
| ||||
| ||||
| Post the 2 files here and I'll see if I can find the difference for you.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
03-25-2006, 04:28 PM
| ||||
| ||||
| Check your email. 
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
