First program

[Larry Myers]

Hi all,

I posted a month or so ago that I am a new guy here and just starting out with my first CNC. I bought the Sharp 2412 w/Fanuc oi.

I’ve written my first program and was really hoping that someone might be willing to go over it for me. I have pasted it below.

This is an aluminum disk, 8” od and .75” thick. It has a tapped center hole that is a 3/8-16 along with a .175” deep counter bore. Along the X axis are two holes at +3.5” and -3.5” that are 5/16-18. Then there is a 5/8” wide slot that is .45” deep along the Y axis.

Any criticism would be very helpful Thanks so much in advance.

PS: I sure hope a posting like this is OK. If not, please accept my apologies.

Larry

EDIT: I deleted my program-Got some help from the G-Code section. Thanks for looking.