Hello-
I am having issues with my 'Sharp knee mill retrofit w Anilam 1100M'. When I turn the mill on it leaves (3) messages saying:
- '+x +y hard limit reached!'
- 'M4 motion board (s) + D2 distrib. board system detected!'
- 'port activated for axis: x y z'
When I engage the servos, a message comes up saying 'servo delay please wait'. After about 3 seconds the work table will rapid a few inches in the 'x' and 'y' axis and a message will pop up saying 'servos off!'
I don't know if one of the servos is going out or what?
Any help would be mucho appreciated!
Thnx, Stephen

Similar Threads: