| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-18-2010, 08:22 PM
| |||
| |||
I have some Copley Xenus XSL-R servo drives. These drives are specified to work with resolvers as the primary feedback device and have a reference frequency of 7.5 KHz. Shopping around on Ebay I have found some deals, but most seem to require a lower reference frequency (usually around 1 KHz). how critical is it to match this frequency? has anyone had luck with mismatched drive / resolver pairs? Also, any suggestions on an inexpensive resolver would help as well.  |
|
| Tags |
| encoder, resolver |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NO THC for waterjet cutting, so how critical is nozzle standoff distance? | douglasco | CNC Plasma and Waterjet Machines | 1 | 09-05-2008 10:15 AM |
| MasterCAM H&T matching | Cory | Mastercam | 9 | 04-20-2008 05:35 PM |
| 5/8 Ballscrew Critical speed | LazyMan | DIY-CNC Router Table Machines | 1 | 02-13-2008 06:06 AM |
| Need Help Matching Steppers To Screws | jeffg | Stepper Motors and Drives | 1 | 02-23-2007 07:57 AM |
| Matching the electronics | Parameter | General Electronics Discussion | 6 | 07-15-2005 11:45 AM |
| | |
Linear Mode
