Need Help! Aerotech amps and servo - CNCzone.com-The Largest Machinist Community on the net!

HONDAPETE · #1 12-28-2009, 03:22 AM

Hi I have two Aerotech AS32020 Amps and BM75 Servos I can find info on the servos but no connection detail for the amps, they would have been in a unidex unit can I drive them from a pc if I build the required PSU. Thanks for any help best regards peter

Al_The_Man · #2 12-28-2009, 10:59 AM

I have had excellent response from Aerotech support when requesting info on legacy equip.
Just as recently as last week.
Al.

HONDAPETE · #3 12-28-2009, 01:06 PM

Thanks for the advice, aerotech wont give connection data for the amps, classed as confidential information. My last resort was here !

Al_The_Man · #4 12-28-2009, 03:17 PM

Those are DCBL motors, take a look at the DCBL drives and see if any resemble them, they are probably re-labled due to proprietary end user.
Post a picture of the drive, I may be able to locate it in a catalogue.
Al.

NicoRubies · #5 01-05-2010, 03:50 AM

Hi Peter,

What type of Unidex controller would this AS32020 plug into? U511?

Nico

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Hurco Fet Servo amps	DonnieET	HURCO	1	01-26-2009 10:14 PM
Cleaning Fanuc Power supplies, Servo amps?	FanucIssues	Fanuc	4	06-07-2007 02:43 PM
Wanted A/C servo amps & motors	Bap	Servo Motors and Drives	1	05-13-2007 12:23 PM
older Brush Servo amps	miljnor	Haas Mills	2	02-18-2006 09:06 PM
DC servo amps	converterk	CamSoft Products	1	12-21-2003 11:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)