| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-17-2005, 07:39 AM
| |||
| |||
Hi, I've been offered the servos of a bridgeport series 1 mill. Approx. 70volt and 22Amp. Now I've looked at the G320 drive and it's limited to 20Amp but voltage ok to 80. Has anyone added encoders and used these larger DC brushed servo motors with gecko drives? If so, any problems that I need to consider? I'm assuming here I can't use tachometers on the motors. Cheers GalaticDan  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gecko in Bridgeport BOSS | zcases | Gecko Drives | 30 | 11-21-2009 10:47 PM |
| Servos, steppers, drives and encoders, Oh my | MobilDave | Servo Motors and Drives | 1 | 09-10-2004 07:04 AM |
| Servos or Steppers..... and other gecko related questions | UKRobotics | Gecko Drives | 11 | 04-19-2004 02:14 PM |
| servos (encoders, drives) | gv71 | General Electronics Discussion | 3 | 03-31-2004 12:43 AM |
| Gecko Drives | ninewgt | Gecko Drives | 8 | 06-23-2003 08:12 PM |
| | |
Linear Mode
