Need Help! renco encoder - CNCzone.com-The Largest Machinist Community on the net!

dhaddox · #1 10-05-2009, 03:28 PM

I have a dc servo motor with a renco part no 77678-184. I need the specs/wiring diagram for it. Renco's web site appears to be down. Any help would be appreciated. Thanks

Bob Setbacken · #2 10-07-2009, 06:05 AM

Contact Ed Burk at 805 562 1127 and he can get you the info you need. Regards, Bob

mactec54 · #3 10-07-2009, 06:32 AM

Hi dhaddox

Give Renco a call they are great to deal with & will have the information you need for you encoder

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RENCO encoder replacement	yorkma	Servo Motors and Drives	13	01-20-2012 05:34 PM
Need renco encoder information	nchapin	Milltronics	0	01-04-2008 11:37 AM
Separate PS For Renco Encoder	kkilst	Gecko Drives	3	05-03-2006 05:49 AM
renco encoder info needed	sendkeys	General Electronics Discussion	11	09-17-2004 08:05 AM
Renco open end encoders	ynneb	General Electronics Discussion	3	03-23-2004 09:52 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)