Need Help! Mitsubishi and Panasonic interface Cable - CNCzone.com-The Largest Machinist Community on the net!

Old Poni · #1 08-06-2009, 04:49 AM

Hello.

We have Chinease vertical glass grilling machine YG2580DP.
PLC Mitsubishi FX1S 30MT and servo drive Panasonic MDDDT5440 (Minas A4).
Both cables X & Y from Panasonice side have incorrect connections inside 50 pin plug (CN X5).
May be somebody has wiring diagram for this connection.
From manufacture no reply.
Thank you.

CNCMAN172 · #2 08-06-2009, 11:23 AM

OldPony,

If you go to the Panasonic Electric website you will be able to pull down the PDF manual for the A4 drives and they do detail the wiring for the 50 pin connector your interested in rewiring. I have worked on many Panasonic servo motors and these documents are invaluable.

CNCMAN172

dan_barber · #3 10-15-2009, 11:35 AM

http://www.ctiautomation.net/Panasonic-User-Manuals.htm has manual for A4.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mitsubishi TRA41 servo Drives - interface help please	kudos	Mazak, Mitsubishi, Mazatrol	14	03-22-2012 08:47 PM
Need Help!- Boxford TCL160 interface to Mitsubishi Freqrol drive and a few other questions	M100	General CNC (Mill and Lathe) Control Software (NC)	0	07-23-2009 06:58 PM
Need A Quote- Cable for Mitsubishi inverter Freqrol A 500	Tahir Iqbal	CNCzone Club House	0	07-25-2008 06:00 AM
mitsubishi cable	rosli	Servo Motors and Drives	0	05-06-2007 05:47 PM
Cable layout for 9 Pin D-Profibus interface	interflexo	Computers and Networking	1	11-29-2006 02:03 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)