Need Help!- Yaskawa JUSP-0p02A digital operator

[Dean448]

Hi all,
Anyone have the cable for one of these?

I need to make a cable and need to know which pins the wires are connected to between the operator connector and the DB9 that goes into the servopack.

I can't find this in any of the Yaskawa manuals on line.
Thanks

[jalessi]

The servopack uses RS232 for communication, but not in a standard pinout. This means you will have to build a cable to connect the drive to your PC:

PC (9 pin) Drive
2 ----------- 2
3 ----------- 4
5 ----------- 14

Then on the PC side, connect 4 & 6 and 1 & 7 & 8.

[jalessi]

This is for the DB-9 version

[jalessi]

Hope this really helps!

Jeff...

[Dean448]

Thanks for the respose Jeff,
All this documentation, and the ones I found, are all wiring diagrams used to connect a servopack to a PC. I'm trying to use the digital operator that has a non standard 10 pin connector, which I can't assume is the same as a cable going to a PC.