| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Servo Motors and Drives Discuss servo motors, drivers and other related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-06-2005, 09:18 PM
| |||
| |||
I'm looking at purchasing some of the clifton precision motors as per the "cheap servo's" thread. I know that Jeff has used these motors with good results and sells them on ebay with encoders attached. My question is does the knurl on the rear shaft of the motor have to be turned off? would the encoders still work with it on? I want to know so that i know what shaft diameter to order for the usdigital e2 encoders. Can anyone tell me what size shaft they ordered for these encoders (http://www.usdigital.com/products/e2/ ) and what the final part # was. Has anyone used these motors on a 4X8 table that is belt driven and if so how did they work? Thanks.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extremely basic machining question. | touser | General Metalwork Discussion | 9 | 06-19-2005 01:51 AM |
| Question about power supplies | dowling177 | General Electronics Discussion | 1 | 01-28-2005 08:01 AM |
| Hobbycnc controler question | chas | Hobbycnc (Products) | 3 | 09-09-2004 06:00 PM |
| Just a question about plunge milling. | Machine1 | Hard and High Speed Machining | 4 | 01-28-2004 09:36 PM |
| HF lathe question | rs1300 | General Metal Working Machines | 0 | 01-19-2004 12:22 PM |
| | |
Linear Mode
