Mixing servo and stepper - CNCzone.com-The Largest Machinist Community on the net!

01-19-2005, 10:26 AM

ty1295

Join Date: Jul 2003

Location: southern indiana

Posts: 126

Mixing servo and stepper

permalink

Any problems mixing a servo for 1 axis and stepper on the other?

Reason i ask, is a i just bought a linear slide/ballscrew/stepper motor combo for a project.

I have 3 servo motors also.

Rather than adapt my servo to the stepper, can I just mix and match? Stepper on Y axis, Servo on X?

Will be a plasma cutting table BTW 4' x 4'.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
stepper, half step, servo?? which to get?	blazer928	General Electronics Discussion	4	04-13-2005 01:28 PM
Stepper or servo	lard	General Electronics Discussion	1	11-21-2004 07:57 AM
Another which should I get Servo or Stepper Question.	mysterious	General Electronics Discussion	31	04-05-2004 01:02 PM
Motor selection advise needed? Servo or Stepper	Beezer	DIY-CNC Router Table Machines	1	03-21-2004 01:24 PM
Stepper or servo moters (Lots of ?'s)	Toolmaker	DIY-CNC Router Table Machines	29	02-22-2004 10:49 PM

All times are GMT -5. The time now is 09:06 PM.